Fall is just beginning in Southern Utah, the last thing most people want
to consider are the chilly temps and morning frost coming right around
the corner. Unfortunately, putting off chores like furnace or heat pump
maintenance can create more headaches for homeowners very quickly as summer
transitions into fall.
It is a common misconception that a furnace or heat pump system will operate
just as well when it is turned on in the fall as it did the last winter
it was used. Here are some simple, inexpensive ways to prevent the costly
emergency repairs that can put your family’s indoor comfort at risk.
How do I get my furnace ready to run for winter?
Always take the time to clean out your main furnace or air handler appliance. – Using a wand style vacuum, you can remove months of dirt, cobwebs,
bugs and other debris that can present fire hazards and force your furnace
system to work overtime. Take special care not to touch electrical wires
attached to the furnace or air handler. Loosening or dislodging these
wires can cause an electrical short. It is best to always shut the power
off to your furnace or air handler before cleaning.
Remember to vacuum out heat registers and vents if you can reach them. – Those pesky dust bunnies that hide in these spaces can get sucked
into the heating system and cause a wide array of problems.
Change your furnace filter. – Some homeowners believe that if that filter was changed relatively
close to the end of use last Change furnace filters every 3 monthswinter,
this step can be skipped come next fall. But even when a furnace or air
handler system is not in use, the filters are still being filled up with
dust mites, pet dander, cobwebs and other debris as the air conditioner runs.
Conducting a visual inspection of your furnace or air handler is a crucial
step toward ensuring that your system is ready to take on those creeping
fall chills. – Once you’ve removed the dirt and replaced the filter, turn
on the furnace or air handler and visually inspect the system’s
igniters. If they fail to light or seem sluggish, call a professional
to replace worn-out flame sensor, heat strips or igniters that can compromise
your system and increase the amount of energy your furnace or air handler
uses, which will be reflected in your monthly energy bills. If your system
is a heat pump, make sure and turn the system to heat. Test to verify
that warm air is coming out of your registers before it gets too cold.
Heat pumps are slightly more complicated and should be inspected by a
trained professional yearly.
Fall furnace service is can keep your family safe
Preparing your heating system for the upcoming fall season usually takes
only an hour to complete. Considering all of the hassles and hazards it
can prevent, this is an invaluable step that most homeowners can perform
on their own. Please remember to check all of your Carbon Monoxide Detectors
each year for correct operation.
Remember: having S&S Mechanical provide a 27 pt. Precision Tune Up
can provide the extra piece of mind that your heating system is safe and
ready for cold weather.
For a limited time the 27 pt. Precision Tune Up is only $99.00 and includes
a one free Carbon Monoxide Detector.